How to avoid unnecessary wear

(1) The generator with diesel engine as power, the operation of the engine part is implemented in accordance with the relevant regulations of the internal combustion engine.
(2) Before starting the generator, you must carefully check whether the wiring of each part is correct, whether the connected parts are reliable, whether the brush is normal, whether the pressure meets the requirements, and whether the ground wire is good.
(3) Put the resistance value of the excitation mutant in the large position before starting the diesel generator and disconnect the output switch. The generator crew with a clutch should take off the clutch. First start the diesel engine, and then start the generator after running smoothly.
(4) After the diesel generator starts to run, pay attention to the cases of no mechanical noise, abnormal vibration, etc. at any time. After the confirmation is normal, adjust the generator to the rated speed, the voltage is adjusted to the rated value, and then the output switch is closed to power out. The load should be gradually increased to strive for a three -phase balance.
(5) Diesel generators must meet the same frequency, the same voltage and the same aspects, and the same conditions can be performed.
(6) Diesel generators preparing parallel running must have entered normal and stable operation.
(7) After receiving the signal of "preparing parallel", the entire device is based on the speed of the diesel engine, and the gate is closed at the moment of synchronization.
(8) Diesel generators that are connected in parallel should adjust the load reasonably to balance the effective and non -effective power of each generator. The effective power is adjusted by the diesel engine and the powerless power is adjusted by inspiration.
(9) Diesel generators during operation should pay close attention to the engine sound and observe whether various instrument indicates whether it is within the normal range. Check whether the operating part is normal and whether the temperature rise of the diesel generator is too high. And do a good job of running records.
(10) When the diesel generator stops, the load is reduced first, and the excitation mutant is returned to reduce the voltage to a small value, and then cut off the switch in order to stop the diesel engine operation.